Chapter 5. Using The Web Interface; Starting The Web Interface; Resetting The Fpc To Manufacturing Defaults - Lenovo NeXtScale n1200 Installation And Service Manual

Chapter 5. Using the web interface

Use this information to help you navigate the FPC web-based graphical user interface and manage
components in the NeXtScale n1200 Enclosure.

Starting the web interface

Start the FPC web-based graphical user interface to manage components in the chassis.
You can access the fan power control web interface through an Ethernet connection by establishing a
session with the IP address of the FPC. If you are connecting to the FPC for the first time, you might have to
change the Internet protocol properties on the client computer.
Open your web browser and enter the IP address of the FPC in the address or URL field.
• If the IP address was assigned through a DHCP server, get the IP address from your network
administrator.
• The FPC has the following default settings:
– IP address: 192.168.0.100
– Subnet: 255.255.255.0
– User ID: USERID (all capital letters)
– Password: PASSW0RD (note the number zero, not the letter O, in PASSW0RD)

Resetting the FPC to manufacturing defaults

You can restore the primary FPC to manufacturing defaults through the FPC web interface.
Read the safety information in "Safety" on page iii and "Installation guidelines" on page 25.
To reset the FPC to manufacturing defaults, complete the following steps.
Step 1. Press the reset button for more than 4 seconds to reset the FPC.
© Copyright Lenovo 2017
65