Lexmark XM1140 User Manual page 218

Troubleshooting
Configuration change, some held jobs were not restored [57]
Held jobs are invalidated because of any of the following possible changes in the printer:
•
The printer firmware has been updated.
•
The tray for the print job is removed.
•
The print job is sent from a flash drive that is no longer attached to the USB port.
•
The printer hard disk contains print jobs that were stored when the hard disk was installed in a different
printer model.
From the printer control panel, select Continue to clear the message. For non-touch-screen printer models,
press to confirm.
Complex page, some data may not have printed [39]
Try one or more of the following:
•
From the control panel, select Continue to ignore the message and continue printing. For
non‑touch‑screen printer models, press
•
Cancel the current print job.
•
Add printer memory.
Defective flash detected [51]
Try one or more of the following:
•
Replace the defective flash memory card.
•
From the printer control panel, select Continue to ignore the message and continue printing. For
non‑touch‑screen printer models, press
•
Cancel the current print job.
Disk full [62]
Try one or more of the following:
•
Select Continue to clear the message and continue printing. For non-touch-screen printer models,
press to confirm.
•
Delete fonts, macros, and other data stored in the printer hard disk.
•
Install a printer hard disk with larger capacity.
Disk must be formatted for use in this device
From the printer control panel, select Format disk to format the printer hard disk and clear the message.
For non-touch-screen printer models, press
Note: Formatting deletes all the files stored in the printer hard disk.
to confirm.
to confirm.
to confirm.
218