Troubleshooting The Spa - Cisco ASR 14000 Series Hardware Installation Manual

Troubleshooting the SPA

Troubleshooting the SPA
If you attempt to install a SPA that oversubscribes the SIP, the SPA does not power up, and you receive
an error message similar to the following:
LC/0/2/CPU0:Aug 29 11:52:57.335 : jacket[159]: %JACKET-3-RULES_FATAL_ERROR
: SPA subslot 4: FAILED: Not enough bandwidth for 1xOC192 POS/RPR HHSPA with XFP
When this happens, the SPA subslot is locked in the failed state. To enable the use of the SPA subslot,
perform the following procedure.
Before you perform this procedure, you must resolve the oversubscription of the SIP by removing one
Note
of the SPAs that is causing the oversubscription.
SUMMARY STEPS
1.
2.
3.
4.
5.
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Step 2
hw-module subslot node-id shutdown
Example:
RP/0/RP0/CPU0:router(config)# hw-module subslot
0/1/0 shutdown
Step 3
commit
Example:
RP/0/RP0/CPU0:router(config)# commit
Step 4
no hw-module subslot node-id shutdown
Example:
RP/0/RP0/CPU0:router(config)# no hw-module
subslot 0/1/0 shutdown
Cisco ASR 14000 Series Router PLIM, SIP, and SPA Hardware Installation Guide
7-2
configure
hw-module subslot node-id shutdown
commit
no hw-module subslot node-id shutdown
end
or
commit
Chapter 7
Purpose
Enters global configuration mode.
Administratively shuts down the specific shared port
adapter (SPA) subslot. The node-id argument is entered in
the rack/slot/module notation.
Saves the configuration changes to the running
configuration file and remains within the configuration
session.
Returns the SPA to the up state. The node-id argument is
entered in the rack/slot/module notation.
Troubleshooting the Installation
OL-17456-01