Sfp Module Connections - Cisco ASR 14000 Series Hardware Installation Manual

Chapter 3 Overview: Cisco ASR 14000 Series Router Shared Port Adapters
10-Port Gigabit Ethernet SPA LEDs
The 10-Port Gigabit Ethernet SPA has two types of LEDs: an A/L LED for each individual port and a
STATUS LED for the SPA, as shown in
Figure 3-15
1
Table 3-21
Table 3-21
LED Label
A/L
STATUS
10-Port Gigabit Ethernet SPA Cables and Connectors
The 10-Port Gigabit Ethernet SPA has ten electrical connectors that support SFP modules. Each port can
send and receive traffic using cabling appropriate for the SFP module inserted.

SFP Module Connections

The small form-factor pluggable (SFP) module is an input/output (I/O) device that plugs into the Gigabit
Ethernet optical slots on the 10-Port Gigabit Ethernet SPA, linking the port with a 1000BASE-X
fiber-optic network.
OL-17456-01
10-Port Gigabit Ethernet SPA Faceplate
1
A/L (Active/Link) LED
describes the 10-Port Gigabit Ethernet SPA LEDs.
10-Port Gigabit Ethernet SPA LEDs
Color
Off
Green
Amber
Off
Green
Amber
Cisco ASR 14000 Series Router PLIM, SIP, and SPA Hardware Installation Guide
Figure 3-15.
2 STATUS LED
State Meaning
Off Port is not enabled.
On Port is enabled and the link is up.
On Port is enabled and the link is down.
Off SPA power is off.
On SPA is ready and operational.
On SPA power is on and good, and the SPA is being
configured.
10-Port Gigabit Ethernet SPA Overview
2
3-29