Cisco ASR 14000 Series Hardware Installation Manual page 43

Chapter 3 Overview: Cisco ASR 14000 Series Router Shared Port Adapters
1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA LEDs
The 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA has six LEDs, as shown in
Figure 3-11 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA Faceplate
1
2
3
The WRAP, PASSTHRU, and MATESYNC LEDs apply to the SPA in RPR/SRP mode only.
Note
Table 3-12
Table 3-12 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA LEDs
LED Label
WRAP
PASSTHRU
MATESYNC
CARRIER
OL-17456-01
TX
WRAP LED
PASSTHRU LED
MATESYNC LED
describes the 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA LEDs.
Color State
Off Off
Green On
Amber On
Off Off
Amber On
Off Off
Green On
Off Off
Green On
Amber On
Blinking
Cisco ASR 14000 Series Router PLIM, SIP, and SPA Hardware Installation Guide
1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA Overview
1 3
2
RX
4 CARRIER LED
5 ACTIVE LED
6
STATUS LED
Meaning
Port is not in wrap mode.
Port is in wrap mode somewhere on the ring.
Port is in wrap mode locally.
Port is not in pass-through mode.
Port is in pass-through mode.
Mate port is not synchronized.
Mate port is synchronized.
Port is not enabled by software.
Port is enabled by software, and there is a valid SONET signal
without alarms.
Port is enabled by software, and there is at least one alarm
(LOS, LOF, RDI, and so on).
SRP mode mismatch alarm is indicated.
Figure 3-11.
5
4 6
SPA-OC192POS VSR
3-19