Programming The Memory Feature; Linking And Unlinking The Remote Keyless Entry Key Fob To Memory - Chrysler 200 2017 Owner's Manual

Programming The Memory Feature

To create a new memory profile, perform the following:
NOTE: Saving a new memory profile will erase an existing
profile from memory.
1. Cycle the vehicle's ignition to the ON position.
2. Adjust all memory profile settings to desired prefer-
ences (i.e., seat, side mirror and radio station presets).
3. Push and release the set (S) button on the memory
switch, then push the memory button (1) within five
seconds. The instrument cluster display will display
which memory position is being set.
If desired, a second memory profile can be stored into
memory as follows:
1. Cycle the vehicle's ignition to the ON position.
2. Adjust all memory profile settings to desired prefer-
ences (i.e., seat, side mirror and radio station presets).
3. Push and release the set (S) button on the memory
switch, then push the memory button (2) within five
seconds. The instrument cluster display will display
which memory position is being set.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 123
NOTE:
• Memory profiles can be set without the vehicle in PARK,
but the vehicle must be in PARK to recall a memory
profile.
• To set a memory profile to your key fob, refer to
"Linking And Unlinking The Remote Keyless Entry Key
Fob To Memory" in this section.
Linking And Unlinking The Remote Keyless Entry
Key Fob To Memory
Your key fob can be programmed to recall one of two
pre-programmed memory profiles with a push of the
unlock button on the key fob.
NOTE: Before programming your key fob you must select
the "Memory To FOB" feature through the Uconnect
system screen. Refer to "Uconnect Settings" in "Under-
standing Your Instrument Panel" for further information.
To program your key fob, perform the following:
1. Cycle the vehicle's ignition to the OFF position.
2. Select the desired memory profile (1) or (2).
3