Table of Contents
Advertisement
Safety Instructions
1.
Read these safety instructions carefully.
2.
Retain this user manual for future reference.
3.
Disconnect this equipment from all AC outlets before cleaning. Do not use liquid
or spray detergents for cleaning. Instead, use only a damp cloth.
4.
For pluggable equipment, the power outlet socket should be located nearby and
easily accessible.
5.
Protect this equipment from humidity.
6.
Place this equipment on a reliable surface during installation. Dropping or letting
the equipment fall can cause damage.
7.
The openings on the enclosure are for air convection to protect the equipment
from overheating. Do not cover the openings.
8.
Ensure that power voltage is correct before connecting the equipment to a
power outlet.
9.
Position the power cord so that people cannot step on it. Do not place anything
over the power cord.
10.
All cautions and warnings on the equipment should be noted.
11.
If not used for a long time, disconnect the equipment from the power source to
avoid damage by transient overvoltage.
12.
Never pour liquid into the openings. This can cause fire or electrical shock.
13.
Never open the equipment. For safety reasons, the equipment should only be
opened by qualified service personnel.
14.
If one of the following occurs, have the equipment checked by authorized ser-
vice personnel:
The power cord or plug is damaged.
Liquid has penetrated the equipment.
The equipment has been exposed to moisture.
The equipment is malfunctioning, or does not operate according to the user
manual.
The equipment has been dropped or damaged.
The equipment shows obvious signs of breakage.
15.
Do not store this equipment in an environment where the temperature fluctuates
below -20 °C (-4 °F) or above 60 °C (140 °F) as this can cause damage. The
equipment should be stored in a controlled environment.
16.
CAUTION: Batteries are at risk of exploding if incorrectly installed. Replace only
with the same or equivalent type recommended by the manufacturer. Discard
used batteries according to the manufacturer's instructions.
The sound pressure at the operator position does not exceed 70 dB (A), as per IEC
704-1:1982.
DISCLAIMER: These instructions are provided according to IEC 704-1. Advantech
disclaims all responsibility for the accuracy of all statements contained herein.
DS-570 User Manual
vi
Advertisement
Table of Contents
