Water Tank - Bosch TES506 series Instruction Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
The water ilter does not stay 
in position in the water tank 
(17).
Check

water tank

The coffee grounds are not 
compact and are too wet.
Clean brewing unit
Coffee or milk froth quality 
varies considerably. 
Water dripped onto the 
inner loor of the appliance 
when the drip tray (8) was 
removed.
Insert brewing unit
Restore the unit to its original 
factory settings ("Reset").
You will ind the telephone numbers at the back of these instructions.
The water ilter is not 
mounted correctly.
Water tank has been 
incorrectly inserted or the 
new water ilter has not 
been rinsed according to 
instructions.
Carbonated water in the 
water tank.
The grinding setting is too 
ine or too coarse, or not 
been used.
Brewing unit (5) is soiled.
Too much pre-ground   c offee 
in the brewing unit (5).
The brewing unit's 
mechanism is stiff.
Build-up of limescale in the 
appliance.
Drip tray (8) removed too 
early.
Brewing unit (5) is missing 
or was not recognised.
You changed some settings 
and want to discard them.
Firmly press the water ilter 
straight down into the tank 
connection.
Insert the water tank   c orrectly 
or rinse the water ilter accord
ing to   i nstructions and then 
switch on.
Fill the water tank with fresh 
tap water.
Adjust the grinding unit to a 
coarser or iner setting, or use 
2 level measuring spoons of 
ground coffee.
Clean brewing unit (5).
Clean brewing unit (5). Pour in 
no more than 2 level measur
ing spoons of ground coffee.
Remove and clean 
the brewing unit, see 
"Maintenance and 
daily cleaning".
Descale the appliance as 
described in the instructions.
Wait a few seconds after 
the last drink was dispensed 
before removing the drip tray 
(8).
Switch off the appliance with 
the brewing unit (5) in place, 
wait three seconds and switch 
on the appliance.
Turn off the unit with the power 
on/off switch 
 (9). Press 
and hold the 
the 
 (12) button and 
h / g
turn the appliance on with the 
power on/off switch 
Conirm by pressing the start 
button 
 (10). The factory 
settings are now activated.
 (13) and 
j
 (9). 

Advertisement

Table of Contents
loading

Table of Contents