Bosch TES506 series Instruction Manual page 20

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Never use vinegar, vinegar-based products, 
citric acid or citric acid-based products!
Never put descaling tablets or other descal
ing agents in the ground coffee drawer or 
the drawer for cleaning tablets (4)!
Duration: approx. 25 minutes.
 If there is a ilter in the water 
tank (17), it needs to be removed before the 
descaling programme is run.
If the message 
Descale required!
on the display, press the 
(13) for 3 seconds and then press the 
button (10). The descaling   p rogramme will 
start.
To descale the appliance before being 
prompted, press the  
at least 3 seconds. Then press the 
button (13) briely twice. Turn the upper 
rotary knob (15) until 
appears in the display. To start the descaling 
procedure, press the 
The display will guide you through the 
programme.
Empty drip tray
Insert drip tray
● Empty drip tray (8) and replace them.
 If the water ilter is activated, the 
display will prompt you to remove the ilter 
and then press the 
Remove the ilter now if you have not 
already done so. Press the 
   b utton 
j
 button (13) for 
j
Start descaling
 button (10).
 button (10) again. 
 button (10).
Fill descaler
Press start
● Pour lukewarm water into the empty 
water tank (17) up to the 
then dissolve 1 Bosch descaling tablet 
TCZ8002 in it. When using TCZ6002, 
2 tablets must be dissolved.
● Press the 
Place container
Press start
● Place a receptacle with a capacity of at 
least 0.5 litres under the outlet (6a).
● Press the 
Descale in progress
The descaling pro  g ramme will now run for 
about 20 minutes.
Clean / Fill water tank
Press Start
● Rinse the water tank (17) and reill it with 
fresh water up to the 
● Press the 
Descale in progress
The descaling pro  g ramme now runs for 
about 3 minutes and rinses the appliance.
j
Empty drip tray
Insert drip tray
● Empty drip tray (8) and replace them.
Replace the ilter if one is being used. The 
appliance has completed descaling and is 
ready for use again.
 Wipe down the appliance using 
a soft, damp cloth to immediately remove 
any descaler residue. Such residue can 
cause corrosion. New sponge cloths may 
contain salts. Salts can cause rust ilm 
on stainless steel and must therefore be 
washed out thoroughly before use.
 mark and 
 button (10).
 button (10).
 mark.
 button (10).

Advertisement

Table of Contents
loading

Table of Contents