Water Filter - Bosch VeroCafe TIE20 Series Information For Use

¡ For technical reasons steam can
escape from the appliance.
¡ If you press a button, a signal tone
sounds. You can deactivate the
signal tone in the basic settings.
Tip: Check and set the water hard-
ness before using your appliance.
Note
The first beverage will not yet have its
full aroma if:
¡ You are using the appliance for the
first time.
¡ You have run a service pro-
gramme.
¡ You have not used the appliance
for a long time.
Do not drink the beverage.
Tip: You will get a stable, fine-pored
crema after you have started up your
appliance and dispensed a few cups.
6.4 Water filter
You can use a water filter to minimise
limescale deposits and reduce impur-
ities in the water.
Inserting or replacing a water filter
If you have to change the inserted

water filter,

lights up on the dis-
play.
1
Depending on the appliance specifications
1
ATTENTION!
Possible damage to the appliance
due to limescale build-up.
▶
Change the water filter in good
time.
▶
Change the water filter after
2 months at the latest.
▶
Observe the display messages.
Requirement: The appliance is
switched on.
Press and hold buttons
1.
simultaneously for at
least 3 seconds.
Press button
2.
display shows "W. hardness".
Confirm with "ok" button
3.
Press button
4.
display shows "Water filter".
Confirm with "ok" button
5.
a The display shows "Filter act.".
Immerse the water filter in a glass
6.
of water with the opening facing up
and press the sides together lightly
until no more air bubbles rise to
the surface.
→ Fig. 7
Set the water hardness on the
7.
aroma ring of the water filter.
Press the water filter firmly into
‒
the empty water tank.
→ Fig. 8
You can find out the water hard-
ness from your local water sup-
plier.
Fill the water tank with water up to
8.
the max mark.
Insert water tank into the appli-
9.
ance.
Place a container with a capacity
10.
of at least 1.0 l under the outlet.
first time en
and
until the
⁠ .
until the
⁠ .
45