Credit Information And Subscription Management (Experimental); Identification, Device Information & Open Api - iSocket 3G User Manual

iSocket ® 3G
until 8 o'clock in the morning every day except weekends and support this temperature
till night-time. Even that complex setup is possible if you add the following rules to the
scheduler:
SCHEDULER+6:00pm,*,SOT=64F
SCHEDULER+7:00am,*,SOT=73F
SCHEDULER+7:01am,Sat,SOT=64F
SCHEDULER+7:01am,Sun,SOT=64F
Let's look at this example. Every day at 6pm (18.00) we set the "switch-off" temperature
to 64F, but every day at 7am (7.00) we override this to 73F. Why not at 8am (8.00)? We
suppose the room will heat up to the desired temperature in one hour. Because we don't
want to heat the room at weekends we override the temperature to 64F again just one
minute later after it was set to 73F – on Saturday and Sunday only. For Celsius the logic
is the same, just use values in Celsius with "C" at the end. Provided the thermostat
function is enabled, the thermostat is configured for heating mode and the temperature
sensor is functioning properly - see Chapter 7 for details.
11. Credit Information and Subscription Management
(experimental)
NOTE! Correct operation of these experimental features cannot be guaranteed. We reserve the
right to remove these features in future versions of devices. The absence or incorrect function
of these features on your device will not be covered by warranty.
You can get SIM card credit information. Not all operators provide such service. With
prepaid cards this service is usually available. For the monthly mobile subscriptions it is
usually not available. You can also activate some UMS codes remotely.
Command
CREDITUMS=*X#
CREDITUMS=NO
CREDITUMS?
CREDIT
SIMCARD*X#
12. Identification, Device Information & Open API
Business customers with several locations can configure each individual iSocket with a
unique ID and use this ID as an identifier on their service pool. The ID must have a
maximum of 8 characters – only latin characters and numbers are allowed. You may store
the ID on the device permanently and enable or disable the display of this ID with an
additional setting.
Open API for developers
iSocket 3G has Open API for developers who want to build any apps or services around
this product. All settings mentioned in this user manual can be configured via that API
over the cellular network. Protocol is MQTT. Please contact us for details and follow our
project on the following websites www.isocket3g.com, www.cecohome.com,
www.isocketsystems.com
© Copyright iSocket Systems 2017
All rights reserved. Version 1.0.2-EN
Description
To install UMS code for balance check. For
ex., CREDITUMS=*100#. Ask UMS code
from your mobile operator
Remove UMS code for balance from memory
Information about CREDITUMS settings
Information about balance (CREDITUMS
must be pre-installed)
To manage your subscription by UMS codes
- 24 -
www.isocket3g.com
Response
CREDITUMS =*100# -
OK
CREDITUMS =NO - OK
CREDITUMS: *100#
Response from mobile
operator
Response from operator
Type
Conf
Conf
Inf
Ctrl
Conf
English