Manual Managing; Multi Texting Mode - iSocket 3G User Manual

iSocket ® 3G
the equipment connected to the device (e.g. router) will be restarted. After a call to iSocket
the action occurs immediately. The action must be pre-configured. There is no action
configured by default. Keep in mind that you are not able to configure the active actions if
the security number list (Chapter 5.1) is not configured. This is because the password
protection is not available for calls, so anyone can call to the SIM card number if there is
no security numbers list protection and this call may cause unwanted reboot. Accordingly,
if you are going to disable the security numbers list protection, then the option RING goes
into the value "NOACTION" automatically. However, you can allow anyone access to the
active action by call using the command RINGPUBLIC=ON. This will allow any number -
even landline phones or phone numbers that cannot be recognized - to perform an action
by calling the iSocket. This will not affect other security settings (Chapter 5).
In response to the activating call the device will send you a message. You can configure a
call response instead of an SMS. Read more about this in Chapter 6.2. The following table
indicates which actions can be pre-configured.
Command
RING=SWITCH
RING=RESTART
RING=PULSE
RING=ON
RING=OFF
RING=NOACTION Ignore phone calls
RING?
RINGPUBLIC=ON
RINGPUBLIC=OFF Does not allow any action for unauthorized
RINGPUBLIC?

4.3 Manual Managing

The main power socket can be managed manually. You can switch it manually by a hidden
button which is on the front panel next to the logo. The button can be activated with a
suitable thin mechanic tool. Pressing this button switches the main power socket to a
negative value. So, if it was turned off, it will be turned on and vice versa.

4.4 Multi Texting Mode

If you want to send several commands at once, you may use a semi-colon ";" between
commands. Do NOT use spaces. This syntax allows you to save credit and time by using
only one message. This syntax is also designed for developers. Commands will be
executed one by one in the order they are written. You should understand all features of
the device well before you start to benefit from the Multi Texting Mode.
Example: MAKEMEBOSS;RING=RESTART;RESTARTTIME=5
© Copyright iSocket Systems 2017
All rights reserved. Version 1.0.2-EN
Description
Switching (changing status to negative) main
power socket by phone call
Restart (return to the same status after a certain
period of time) main socket by phone call. Time for
restart set by RESTARTTIME.
Send a pulse to a relay by phone call. The duration
of the pulse can be configured by command
PULSETIME.
Turn on main power socket by phone call
Turn off main power socket by phone call
Informs what action configured
Allows one of the above actions for any number. It
will ignore security list settings configured in
Chapter 5. Use this setting only if you understand
the consequences!
numbers. The defaultt factory setting.
Recommended!
Informs about RINGPUBLIC value
- 10 -
www.isocket3g.com
Response
RING=SWITCH – OK
SECLIST is not active!
RING=RESTART – OK
SECLIST is not active!
RING=PULSE – OK
RING=ON - OK
RING=OFF - OK
RING=NOACTION – OK Conf
RING=(NOACTION),
RESTART,SWITCH
RINGPUBLIC=ON - OK
RINGPUBLIC=OFF - OK Conf
RINGPUBLIC=(OFF),ON Inf
Type
Conf
Conf
Conf
Conf
Conf
Inf
Conf
English