Usb; Error Messages - Delphi DEA600 Owner's Manual

USB

Playing from a USB
The USB port is in the front of the Radio. Five volts DC power is limited to
one amp from this port. Devices such as iPod that require greater current will
not charge from this port.
1. Connect the USB.
2. The USB Source media is automatically selected and plays the
media content of the USB device if no other app of higher priority is
in use (I.E. phone call, video, reverse mute...).
3. To control and browse the selected media source refer to sections
Media Sources and Media Audio Control Soft key for further
information.
Drives
The USB MP3 players and USB drives connected must comply with the USB
Mass Storage specification:

MS-Dos partition only

Class specification (USB MSC) and supports formats of FAT32,
FAT16, NTFS, and HFS+

Hard disk drives may be played, but they are not supported.

The radio will not be able to play back write-protected music.

MTP players are not supported.
For MP3 Files
MP3 files must meet the following guidelines for proper playback:

Bit rates: 32, 40, 48, 56, 64, 80, 96, 112, 124, 160, 192, 224, 256,
320 kbps for MPEG-1 Audio Layer 3

Sampling frequencies: 32, 44.1 and 48 kHz for MPEG-1 Audio
Layer 3

Maximum number of folders: Eight folders with 255 files per folder

Maximum of 1,000 files on a disc

M3u and pls playlist versions supported

Recorded on a CD-R or CD-RW with a maximum capacity of 700
MB
Owner´s Manual DEA600 Radio

Error Messages

If an "UNSUPPORTED" message is displayed, it could be for one of the
following reasons:
If "NO MUSIC" message is displayed, it could be because there are no
playable MP3 files.
iPod
This Radio supports the following iPod models:
Other iPods may be played, but functionality is not guaranteed.
The radio provides up to 1A of charge, so any device connected to the USB
that requires less than 1 A will be charged.
There may be problems with the operation and function in the following
situations:
Playing from an iPod
To connect an iPod:

When a MTP Player or a USB device with unsupported format or
partition is connected.

When the device is damaged.

When the connected device was not connected as mass storage
device.

®
iPod classic (6G)
 ®
iPod nano ( 6G, and 7G)
 ®
iPod touch (4G, and 5G)

®
iPhone (4S, 5, 5C, and 5S)

When connecting an iPod on which a more recent version of the
firmware is installed than is supported by the Radio.

When connecting an iPod with firmware from other providers is
installed.
1. Connect one end of the standard iPod USB cable to the iPod's dock
connector.
2. Connect the other end to the USB port in the front of Radio.
17 | P a g e