Table of Contents
Advertisement
Loading Envelope in the Bypass Tray
Use the following guidelines to load each size of envelopes in the bypass tray:
IMPORTANT:
•
Never use envelopes with windows, coated linings, or self-stick adhesives. These lead to paper jams and can cause damage to the
printer.
NOTE:
•
When five envelopes are set on the bypass tray, a misfeed may occur. If this happens, reduce the number of envelopes.
•
If you do not load envelopes in the bypass tray right after they have been removed from the packaging, they may bulge. To avoid
jams, flatten them as shown below before loading the envelopes in the bypass tray.
• Com 10/DL
Load the envelopes short edge feed with the flaps closed and the print side up. Ensure that the flaps come at the right
when you face towards the printer.
• Monarch
You need to pull up and slide the length guide. Load the envelopes short edge feed with the flaps closed and the print side
up. Ensure that the flaps come at the right when you face towards the printer.
• C5
Load the envelopes short edge feed with the flaps open or closed and the print side up.
Ensure that the flaps come at the bottom with the flaps open or at the top with the flaps closed when you face towards the
printer.
When you print with the orientation of the 1, position of the envelopes may be distorted on the output tray. In this case, set
the orientation of the 2.
1
86
Printing Basics
2
Advertisement
Table of Contents
