Genie Z-30/20N Service Manual page 105

Service Manual
Steer Axle Components
9 Loosen the castle nut one full turn and then
torque to 35 ft-lbs / 47 Nm.
10 Install a new cotter pin. Bend the cotter pin to
lock it in place.
Note: Always use a new cotter pin when installing a
castle nut.
11 Install the dust cap, then the tire and wheel
assembly.
12 Lower the machine and remove the blocks.
13 Torque the wheel lug nuts to specification.
Refer to Specifications, Machine Torque
Specifications.
92
Z-30/20N • Z-30/20N RJ • Z-34/22 • Z-34/22N
April 2016
Part No. 139378