FLIR M100SERIES Nstallation & Operation Instructions page 79

Note: UPB mappings apply to individual cameras rather than to specific JCU-3
keypads. This means that, if you are using a single JCU-3 keypad to control two
M100 / M200 Series cameras, UPB number 1 could be configured to initiate a
different action on each camera.
To configure JCU-3 user programmable buttons (UPBs) using the camera's Web interface:
1. From the camera's Web interface, click Setup on the top menu.
The Setup page is displayed.
2. From the left-hand panel, click JCU.
The UPB Configuration panel is displayed.
3. From the UPB Button list, select the button you wish to configure.
4. From the UPB Action list, choose the camera action you wish to associate with
that UPB button.
5. Repeat steps 3 and 4 for each UPB you wish to configure.
6. Click Set to save the UPB Configuration.
The Live Video page is displayed.
System operation and setup
79