Suppression Ferrites; Connections To Other Equipment; Declaration Of Conformity; Product Disposal - FLIR M100SERIES Nstallation & Operation Instructions

Note: Where constraints on the installation prevent any of the above
recommendations, always ensure the maximum possible separation between different
items of electrical equipment, to provide the best conditions for EMC performance
throughout the installation

Suppression ferrites

• Cables may be pre-fitted or supplied with suppression ferrites. These are important
for correct EMC performance. If ferrites are supplied separately to the cables (i.e.
not pre-fitted), you must fit the supplied ferrites, using the supplied instructions.
• If a ferrite has to be removed for any purpose (e.g. installation or maintenance), it
must be replaced in the original position before the product is used.
• Use only ferrites of the correct type, supplied by the manufacturer or its authorized
dealers.
• Where an installation requires multiple ferrites to be added to a cable, additional
cable clips should be used to prevent stress on the connectors due to the extra
weight of the cable.
• If your camera installation requires long cable runs, you may need to fit additional
ferrites to maintain acceptable EMC performance.

Connections to other equipment

Requirement for ferrites on non-FLIR cables
If your FLIR equipment is to be connected to other equipment using a cable not
supplied by FLIR, a suppression ferrite MUST always be attached to the cable near
the FLIR unit.

Declaration of conformity

FLIR Systems Inc. declares that this product is compliant with the essential requirements
of EMC directive 2004/108/EC.
The original Declaration of Conformity certificate may be viewed on the relevant product
page at www.flir.com.

Product disposal

Dispose of this product in accordance with the WEEE Directive.
The Waste Electrical and Electronic Equipment (WEEE) Directive requires the
recycling of waste electrical and electronic equipment.

Warranty registration

To register your FLIR product ownership, please visit
It is important that you register your product to receive full warranty benefits. Your unit
package includes a bar code label indicating the serial number of the unit. You will
need this serial number when registering your product online. You should retain the
label for future reference.
12
www.flir.com and register online.