FLIR M100SERIES Nstallation & Operation Instructions page 75

A frame-rate selector at the lower-right of the page enables you to change the rate at
which video frames are displayed. This rate applies only to this instance of the web
browser. Video streams for other users are not affected.
At the top of the page, the Help menu shows software version information. This
page includes information about the camera, including hardware and software revision
numbers, part numbers, and serial numbers. Before contacting FLIR Technical Support
for assistance, make a note of the information from this page.
Use the Log out link at the top of the page to disconnect from the camera and stop
the display of the video stream. If your web session is inactive for more than 20
minutes, you will be logged out automatically.
In the lower left of the screen are two indicator lights: Control and Status. Initially the
Control light is off (black), indicating that you are not able to control the camera.
When multiple users are connected to a camera, only one user at a time can issue
commands to the camera. If another user has control of the camera, the Control light
is yellow. To request control of the camera, click on the yellow or black light, or by
sending a command to the camera. The Status light may turn off (black) temporarily,
while waiting for a response from the camera. There may be a slight delay responding
to your inputs while the browser waits for a response from the camera.
In addition, when you move the mouse cursor over the video display, pan & tilt arrows,
zoom buttons, and a snapshot button are shown.
The pan & tilt arrows and zoom buttons are shown at the lower-left of the screen; the
snapshot button is shown at the upper-right.
System operation and setup
75