FLIR M100SERIES Nstallation & Operation Instructions page 58

Note:
• If it is not possible to route the camera cables through the mounting surface, cut a
hole in the side of the riser, and route the cables through the riser sidewall. You
may need to loop the cables around within the riser base, so that they can be
passed through the hole you have cut in the side of the riser.
• If routing the camera cables through the riser sidewall, and the camera is mounted
ball-up, do NOT seal the riser base with either the supplied gasket, or sealant.
Sealing may result in water pooling inside the riser.
• If routing the camera cables through the riser sidewall, and the camera is mounted
ball-down, do NOT seal the connection between the camera base and the top
surface of the riser with the supplied gasket. Sealing may result in water pooling
inside the riser.
58