Disassembly Process; Equipment Needed & Product Overview; Ek-810U/Ek-811W - Eiki EK-810U Service Manual

Chapter 2

Disassembly Process

2-1 Equipment Needed & Product Overview
1. Screw Bit (+) :105
2. Screw Bit (+) :107
3. Screw Bit (-) :107
4. Hex Sleeves 5 mm
5. Tweezers
6. Knife
7. Projector
* Before you start:
- This process is protective level II. Operators should wear electrostatic chains.
- When disassemble Engine module , please notice that it require specific environmental
conditions (clean room).

EK-810U/EK-811W

2-1