B&C Electronics
7.14 ANALOG OUTPUT N°2 RANGE
Active keys: [MODE] - [/\] [\/] - [ENT]
Active keys: [MODE] - [/\] [\/] - [ENT]
Active keys: [MODE] - [/\] [\/] - [ENT]
IMPORTANT NOTE 1: if the value related to P1 is higher than the value related to P2 the analog
output will be the "reverse", otherwise will be the "direct" type.
7.15 SET-POINT A OPERATING MODE
Active keys: [MODE] - [/\] [\/] - [ENT]
7.16 SET-POINT A FUNCTION
Active keys: [MODE] - [/\] [\/] - [ENT]
Operator's Manual - Rev. C - 05/05
|CAL OUT2: 0/20mA|
0/20mA (4/20mA): range selected
|CAL P1: 0.000 ppm|
P1: begin of range
0.000 PPM: measuring value related to 0/4 mA
|CAL P2: 2.000 ppm|
P2: end of range
2.000 PPM: measuring value related to 20 mA
|SET A ACT:On/Off|
On/Off, PWM, PFM: set-point A operating mode
|SET A F. : LO
LO: minimum (relay activated for meas. below set-point)
HI: maximum (relay activated for meas. above set-point)
_
|CAL OUT2: 4/20mA|
_
_
_
(PWM-PFM)
_
|
|SET A F. : HI
CL 7685
_
_
|
-
–
36