B&C CL 7685 Operator's Manual page 20

B&C Electronics
[MODE] to go to
----------------------------------
D1
[CAL]
[MODE] to go to
----------------------------------
D2
[CAL]
[MODE] to go to
----------------------------------
D3
[CAL]
[MODE] to go to
----------------------------------
D4
[CAL]
Operator's Manual - Rev. C - 05/05
|0.700 ppm Cl2
to activate the Zero/Sensitivity calibration procedure
|TEMP.:
22.0°CM|
M: manual value
to activate the Temperature calibration or the manual Temperature value
selection procedures
|SA: 0.60 * F
à
0.60 :set-point value
à :set-point actual state
* : Alarm on set point A activated
F : selected action (F=PFM - W=PWM - O=on/off)
L : selected function low/high (L-H)
to activate the programming sequences for set-point A value, hysteresis and
delay time
|SB: 0.80 * O
0.80 : set-point value
ì : set-point actual state
* : Alarm on set point B activated
O : selected action (F=PFM - W=PWM - O=on/off)
H : selected function (L-H)
to activate the programming sequences for set-point B value, hysteresis and
delay time
_
Cl/ClO /O
|
2 3
_
Temperature value
_
Set-point A parameters display
L|
_
Set-point B parameters display
H|
ì
values
CL 7685
- –
20