Temperature Calibration - B&C CL 7685 Operator's Manual

B&C Electronics

6.3 TEMPERATURE CALIBRATION

1. [MODE]
D2
2. [CAL]
[MODE]
[/\]+[\/]+[ENT] to press the three keys to turn to factory calibration
3. [/\] [\/]
4. [ENT]
[ENT]
Manual Temperature calibration
[MODE]
1. [/\] [\/]
2. [ENT]
Operator's Manual - Rev. C - 05/05
to go to
|TEMP.: 20.0 °C |
to access the calibration procedure
|CAL T 20.0°C
'>>>>>' ('<<<<<'): Temperature value overrange
to stop the procedure and to go back to D2
to modify the actual reading
to confirm and to go to the manual Temperature adjustment
MESSAGE
| " UPDATE "
Error messages
| Z> 2.0°C
The above message will last for 5 minutes
to acknowledge the message
|" NO UPDATE "
|CAL T.M: 20.0°C|
to stop the procedure and to go back to D2
to modify the actual value
to confirm and to go back to D2
_
_
|
FUNCTION
_
The calibration is accepted
|
_
Zero > 2.0 °C
|
_
calibration not accepted
|
_
CL 7685
- –
26