B&C Electronics
7.8 CELL POLARIZATION VOLTAGE
This polarization voltage is calibrated during the manufacturing and it may be changed by means of
the internal trimmer marked BM(R14).
Remove the back panel to adjust the trimmer, watching the readout.
Active keys: [MODE] - [/\] [\/] - [ENT]
7.9 CALIBRATION MODE
Active keys: [MODE] - [/\] [\/] - [ENT]
7.10 TEMPERATURE COEFFICIENT
Active keys: [MODE] - [/\] [\/] - [ENT]
7.11 INPUT RELATED TO ANALOG OUTPUT N°1 (OPTION 091.3711)
This configuration is available only when the dual output option 091.3711 is installed.
The input corresponding to the output range is selectable as Cl
outputs.
Active keys: [MODE] - [/\] [\/] - [ENT]
Operator's Manual - Rev. C - 05/05
|CAL POL.: -200mV|
POL.-200 mV: actual polarization voltage
|MODE OF CAL:POST|
POST: Postponed calibration mode selected
|CAL TC: 2.00%/°C|
2.00% / °C: Temperature coefficient value
|CAL OUT1: ppm
PPM: input range selected for analog output N°1
_
_
_
(ClO
/O
) or Temperature for the two
2
2
3
_
(°C)
|
CL 7685
-
–
34