Operating The System; Pre-Operation Check - B&C CL 7685 Operator's Manual

B&C Electronics CL 7685

3.3 OPERATING THE SYSTEM

Pre-operation check

The system's controls and indicators are all located on the front panel. (See Fig. 1).
The meter has a LCD display 1 indicating that unit is on.
The cards of the controllers are adjusted at the factory.
If sensors and probes have been connected correctly, as described in the above sections, the system
should function correctly needing only the start up and the parameters calibrations as described in the
following section.
- –
Operator's Manual - Rev. C - 05/05 17