Automatic Calibration Cycle - Hach polymetron 9240 User Manual

Analyzer Overview

3.7 Automatic calibration cycle

The following section gives an overview of the automatic calibration process. For details on
setting up and running this process, refer to the section entitled
9240 is a multi channel analyzer, the user must define which channel will be used for calibration
(see
manual calibration is launched. If the analyzer is set up as a single channel unit, then calibration
will always be made on channel 1 by default.
30
Automatic calibration setup on page 98). The selected channel will also be used when a
Figure 10 Automatic calibration cycle
Calibration on page 93. As the