OCV (Oil control valve)
REMOVAL
1. To remove the cover 1, pull the upper part outward, then lift
up.
2. Disconnect OCV lead wire connector at OCV.
3. Remove the four (4) bolts securing OCV, then remove OCV
and discard OCV gasket.
INSTALLATION
Installation is reverse order of removal with special attention to
the following steps.
• Install gasket and OCV, then tighten bolts securely.
NOTE:
Position the OCV gasket tab as shown at right.
#
Do not reuse the OCV gasket, always replace with new
one.
+ OCV bolt: 12 N·m (1.2 kg-m, 8.6 lb-ft)
• Check to ensure that all removed parts are back in original
position.
ENGINE CONTROL SYSTEM
1. OCV
1
1. OCV gasket
3-71
1