Water Drainage - AEG Favorit CE Instruction Book

Position- and connection instructions

Water drainage

To protect the dishwasher against water damage it is equipped with
a water safety system. In the event of a fault the drainpump starts
automatically and the remaining water inside the dishwasher is
pumped out.
The water safety system also works when the dishwasher is switched off.
However the dishwasher must be connected electrically.
Place the discharge hose over the
sink as illustrated.
It must not at any point be higher up
than 75 cm over the surface which
the dishwasher is standing on. If it
runs higher, operation of the dish-
washer might be impaired.
It is also important to ensure that the
inside diameter of the hose is not
less than 13 mm at any point. If the
discharge hose is too long, it can
easily be cut to the right length.
1. Cut the hose to a suitable
length, using a sharp knife.
2. Fit the elbow supplied onto
the end of the hose.
26