AEG Favorit CE Instruction Book page 43

12. Regeneration
The water chamber for regeneration contains 350 ml water. During regeneration, the regeneration valve is
energized. The 350 ml water runs into the salt container and mixes with the salt to form a brine solution.
In the top of the salt container there is an opening with a small filter, from here the brine solution enters the
softener where the resins are regenerated.
The softener has 5 settings and can be adjusted to suit the degree of water hardness.
The adjustment of the water hardness is described in the short list of service functions.
Table for water hardness adjustment
$GMXVWPHQW
no
WH 1
WH 1
regenaration
WH 2
WH 3
WH 4
WH 5
This table is stored in EEProm. Therefore the values are changeable
by variant configuration. The values on the left specify the actual status and shall only be seen as an
example for this documentation.
- Column „Number water loads“ contains the value, when the regeneration will be run.
o With each dynamic filling step during the cycle, the counter is increased by 1.
A possible refilling is not taken into consideration.
o If the value in the table, linked to the adjusted water hardness, is reached, the regeneration is
activated. At the water hardness WH5 regeneration is done each cycle (counter is not active).
o In all machines, at the end of the program a 50 seconds draining of
regeneration water is run.
Spares Operation - R.Kurzke 02/02
:DWHU QXPEHU RI
KDUGQHVV ZDWHU ORDGV
< 4°dH
4 dH
4 - 12°dH
18 dH
12 - 18°dH
26 dH
18 - 24°dH
32 dH
> 24°dH
50 dH
2SHQLQJ KRXU IRU UHJHQHUDWLRQ
YDOYH
time
60
16
8
8
6
5
0
- 15 -
180 Sek.
180 Sek.
180 Sek.
180 Sek.
180 Sek.
599 513 616 EN