AEG Favorit CE Instruction Book page 12

Instruction book
Filling the rinse aid
Use of rinse aid will result in cleaner and faster drying of the load, since it
helps water and soil to run off. Too much rinse aid may result in streakiness,
too little may cause white spots.
Caution!
Only use rinse aid specifically designed for domestic dishwashers. Never fill
the rinse aid dispenser with any other substance (e.g. vinegar concentrate
or dishwasher detergent) as this would damage the appliance.
The rinse aid dispenser is on the inside of the dishwasher door.
1. Open the lid to the dispenser by
pressing the lid catch towards the
compartment and lift the lid.
2. Fill up with rinse aid; do not overfill.
Maximum inhold ca. 150 ml.
3. Wipe off any spillage carefully to
prevent excessive foaming during
the next wash programme.
4. Close the lid and press until it locks
again.
Fill with rinse aid:
When the indicator light
If dishwasher detergent with rinse aid is used, you can switch off
the lamp that indicates that the rinse aid dispenser is empty.
The dishwasher must be switched off.
1. Press the water softener and functions buttons simultaneously and
hold them pressed in, then also press in the On/Off button.
2. When the lamps for the water softener and functions buttons starts
to flash, you can let go of the buttons.
3. Press the functions button once. The lamps for the functions button
and ended programme cycle starts to flash. Press the button once
more and the light for the ended programme cycle goes out.
Now the function for the rinse aid control light is off.
4. Press out the On/Off button to complete the setting.
To reset the function, follow steps 1 and 2 above and then press
the functions button twice, until the lights for the functions button
and for ended programme cycle begins to flash again.
12
on the control panel is lit.