Connecting To The Water Tap And Drainage - AEG Inventum VVW6025A Instruction Manual

Table of Contents

Advertisement

Available languages

Available languages

when they are made.
• Do not grip the appliance by its door or control panel in order to
move it.
• Make sure that the water inlet and outlet hoses do not get stuck
while positioning the appliance.
• Adjust the appliances adjustable feet to ensure the appliance is
standing level and balanced. Proper positioning of the appliance
ensures problem-free opening and closing of the door.
• If the door of your appliance does not close properly, check if the
appliance stands level on the floor. If not, adjust the adjustable
feet and ensure its stable position.

CONNECTING TO THE WATER TAP AND DRAINAGE

Make sure that the indoor plumbing is suitable for installing
a dishwasher. Also, we recommend that you fit a filter at the
beginning of the water supply in your house to avoid any damage
to your appliance because of any contamination (sand, clay, rust,
etc.)
that might occasionally carried in through the mains water supply.
• Always use the new water inlet hose supplied with your appliance.
If you are using the new water inlet hose, run water through it for a
while before making the connection.
• Connect the water inlet hose directly to to the water inlet tap.
The pressure supplied by the tap should be at a minimum of 0,03
Mpa and at a maximum of 1 Mpa. If the water pressure is above 1
Mpa, a pressure-relief valve should be fitted inbetween.
• After the connections are made, the tap should be turned on fully
and checked for water leakage.
• The appliance is supplied with an double-walled
aquastop. The system automatically cuts off the water
supply if the water inlet hose starts to leak and the space
between the walls is filled with water. Make sure not to
cut into the aquastop or that it gets twisted or stuck.
• The water drain hose can be connected either directly to a drain
pipe with a minimum diameter of 4 cm, or let it run into the sink,
making sure to avoid bending or crimping it. The
free end of the hose must be at a height between
40 and 100 cm
and must not
be immersed in
water.
29
English

Advertisement

Table of Contents
loading

Table of Contents