AEG Favorit CE Instruction Book page 5

Instruction book
In daily use
Never place the dishwasher in operation if the mains cable, water
inlet or drain hose is damaged, or the control panel, work top or
plinth area is damaged such that the inside of the appliance is
freely accessible.
In the event of a fault, first close the tap, then switch off the appliance
and unplug it from the mains. If the appliance is permanently wired to
the mains, remove the fuse.
When removing the electrical plug, grip the plug, not the lead.
Repairs to the dishwasher are only to be carried out by qualified ser-
vice engineers. Improper repairs can give rise to significant hazards
for the user. If your appliance needs repairing, please contact your
local AEG Service Force Centre. Use only spare parts supplied by
these.
If the mains lead is damaged, or is to be replaced for a longer lead,
the cable (obtainable from AEG Service Force) must be replaced by
a service engineer authorised by AEG.
Do not put any solvents in the dishwasher. There is a risk of an
explosion!
Do not sit or stand on the open door, the appliance may tip over.
Before using special dishwasher salt, detergent or rinse aid, make
sure that the manufacturer of these productrs expressly specifies
their use in domestic dishwashers.
The water safety system protects against water damages. The follo-
wing requirements must be fulfilled:
- The dishwasher must be electrically connected when it is shut off.
- The dishwasher must be correctly installed.
- Always shut off the water supply whenever the dishwasher is left
unattended for an extended period.
5