Lan - HP Integrity rx6600 Installation Manual

1. Locate the appropriate receptacle on the rear of the chassis. Plug the power cord into the
receptacle.
IMPORTANT:
PWR 1.
2. Observe the following LEDs at two different intervals to ensure the server is in the standby
power state:
INTERVAL ONE
After you plug the power cord into the server, the BPS flashes amber and an amber light is
present on the hard disk drives.
INTERVAL TWO
Approximately 30 seconds later, the BPS flashes green and the amber light is still present on
the hard disk drives. Standby power is now on.

LAN

The server has two LAN ports that can provide network connectivity.
LAN ports for the server.
Figure 19 Rear Panel LAN Ports
To enable general network connectivity for the server, follow these steps:
If the server has one BPS, plug the power cable into the receptacle labeled
Figure 19 shows the available
Connecting the Cables 41