Removing And Replacing The Memory Carrier Assembly; Removing The Memory Carrier Assembly - HP Integrity rx6600 Installation Manual

5. Insert the PCI/PCI-X/PCIe card into the empty slot and exert firm, even pressure to seat the
card in the slot.
CAUTION:
is reapplied to the slot.
6. Connect all internal and external cables to the PCI/PCI-X card.
7. Close the MRL.
a. Rotate the MRL downward 90 degrees.
b. Push the edge of the MRL down until it clicks into place on the PCI/PCI-X/PCIe card
bulkhead.
8. Close the gate latch to secure the end of the card if it is full length.
9. Replace the top cover. See

Removing and Replacing the Memory Carrier Assembly

The memory carrier assembly encloses the system DIMMs. There is one memory carrier assembly
that is available for the server, the 48-DIMM memory carrier assembly.
The memory carrier assembly has two sides, 0 and 1, each of which contain a 24-DIMM memory
board. System DIMMs seat onto the memory boards.
Table 4 lists the supported memory carrier assembly configurations.
Table 4 Supported Memory Carrier Assembly Configurations
Memory Carrier Configuration
24-DIMM memory carrier (configuration 1)
48-DIMM memory carrier (configuration 2)
CAUTION:
ESD safety precautions can result in damage to the server.

Removing the Memory Carrier Assembly

WARNING!
from the server prior to performing this procedure.
Voltages are present at various locations within the server whenever an AC power source is
connected. This voltage is present even when the main power switch is in the off position.
Failure to observe this warning can result in personal injury or damage to equipment.
To remove the memory carrier assembly, follow these steps:
1. Unlatch the cover release lever on the top cover and remove the memory carrier assembly
cover. See
NOTE:
the top cover release lever must be open.
2. Press the button located in the center of the memory carrier assembly to release the extraction
handles
CAUTION:
result in damage to the extraction handles.
3. Pull up on the extraction handles and rotate them outward 90 degrees
click open.
Ensure that you fully seat the card into the slot or the card can fail after power
"Removing and Replacing the Top Cover" (page
Observe all ESD safety precautions before attempting this procedure. Failure to follow
Ensure that the system is powered off and all power sources have been disconnected
"Removing and Replacing the Memory Carrier Assembly Cover" (page
You do not need to fully remove the top cover to service this component; however,
(Figure 8).
Manipulate the extraction handles with care. Failure to observe this caution can
Memory Boards Installed
1 X 24-DIMM memory board
2 X 24-DIMM memory boards
Installing Additional Components
11).
12).
(Figure 8) until they
21