Installing A Hot-Pluggable Disk Drive - HP Integrity rx6600 Installation Manual

Hide thumbs Also See for Integrity rx6600:

Table of Contents

TIP:

When you receive an HP Integrity rx6600 server from HP, if you ever plan to add other

SAS devices into the system, you should consider moving the SAS devices so they start in bay 1

going upwards instead of Bay 8 going downwards.

Installing a Hot-Pluggable Disk Drive

NOTE:

The replacement disk drive must have the same product number as the disk drive that

you replace.

To install a hot-pluggable disk drive, follow these steps:

Use

Figure 6

Remove the disk drive filler if required. See

(page

15).

NOTE:

fillers in slots that do not contain a disk drive.

Insert the hot-pluggable disk drive into the slot guides, and slide the drive into the slot until it

seats into the socket on the disk backplane.

Close the drive ejector handle by pushing it inward until it clicks into place.

Figure 5 Removing and Replacing a Hot-Pluggable Disk Drive

to determine the next available disk drive installation slot.

Save the disk drive filler for future use. For cooling purposes, always place disk drive

"Removing a Hot-Swappable Disk Drive Filler"

Installing Additional Components

Table of Contents