HP Integrity rx6600 Installation Manual page 29

2. Remove the memory carrier assembly. See
Assembly" (page
NOTE: To avoid damage to the handles, HP recommends rotating the handles inward and
snapping them into place when servicing the system DIMMs or any time the carrier is out of
the chassis. Before replacing the memory carrier, press the button to release the extraction
handles. Use the handles to replace the memory carrier into the chassis.
3. Complete the following memory installation prerequisite tasks before installing the memory:
a. Determine the DIMM load order for the 48-DIMM memory carrier. For more information,
see "Memory Load Order" (page
b. Use Figure 1 1
c. Read, understand, and follow the general guidelines to install memory in the server. See
"Memory Loading Rules and Guidelines" (page
4. Lay the memory carrier assembly on side 0 or side 1 so that the memory carrier side that
contains the DIMM slots that you will install DIMMs into faces upward
5. Remove the memory carrier assembly side cover.
a. Press the release tabs
until the side cover releases from the top center of the assembly.
b. Rotate the side cover slightly to free the tabs from the retaining slots at the base of the
assembly (Figure
c. Lift the side cover off the assembly.
21).
26).
to determine the DIMM slots to populate.
(Figure 9) on both sides of the extraction handle release button
10).
"Removing and Replacing the Memory Carrier
27).
Installing Additional Components
(Figure 9).
29