Removing The Auto-Cutter - Epson TM-U200 series Technical Manual

C o n fid e n tia l

Removing the auto-cutter

1. Open the main cover assembly.
2. Remove 1 screw, and remove the auto-cutter cover. Remove the cable connector from the
auto-cutter cover (See the second part of the illustration below). Then disconnect the auto-
cutter cable from the cable connector for the auto-cutter.
(The illustration does not have the main cover assembly. However, it's not necessary to
remove it.)
Auto-cutter
cable
3. Remove 2 REs.
4. Remove the auto-cutter plate shaft, auto-cutter plate spring shaft, and auto-cutter plate
spring. Then remove the auto-cutter.
Auto-cutter
plate shaft
Refer to the corresponding assembly section(s) in this chapter for assembly procedure.
Rev. A
screw
Auto-cutter
cover
Auto-cutter
TM-U200 Series (Type B) Technical Manual
Connector
Auto-cutter
plate spring
Auto-cutter
plate spring shaft
Disassembly, Assembly, and Adjustment 5-5