Table of Contents
Advertisement
PARTS REPLACEMENT
5.
Control PC Board
[Remove]
If you have already removed 3 Centronics I/F PC Board , perform only step (4).
(1)
Turn the printer upside down.
(2)
Remove the Self-tap Screws (7 places/M3 X 10) fastening the ASSY Plate Bottom.
(3)
Remove the Harness Connector of the Control PC Board from the Centronics I/F PC Board.
(4)
Remove the Self-tap Screws (2 places/M3 X 10) fastening the Control PC Board.
Self-tap Screws
(M3 X 10)
[Caution in assembly]
Attachment is done by reversing the procedures used for removal.
Tighten the screws while pressing the Control PC Board to the Base so that the gap between the Control PC Board
and the Base will be small.
The Harness Connector for the Control PC Board should be attached so that the blue mark can be seen.
Control
PC Board
– 24 –
Advertisement
Chapters
Table of Contents
Troubleshooting
