Hard Drive Backplane; Removing The Hard Drive Backplane - Dell PowerEdge T630 Owner's Manual
Hide thumbs
Also See for PowerEdge T630:
- Owner's manual (176 pages) ,
- Owner's manual (181 pages) ,
- Getting started (2 pages)
Table of Contents
Advertisement
Figure 77. Installing the system battery
1.
system battery
Next steps
1.
Install the cooling shroud.
2.
Follow the procedure listed in the After working inside your system section.
3.
While booting, press F2 to enter System Setup and ensure the battery is operating properly.
4.
Enter the correct time and date in the System Setup Time and Date fields.
5.
Exit System Setup.
Related Links
Safety instructions
After working inside your system
Before working inside your system
Removing the cooling shroud
Hard drive backplane
Depending on the configuration, your system supports one of the following:
•
3.5 inch x8 SAS/SATA backplane
•
3.5 inch x18 SAS/SATA backplane
•
2.5 inch x4 Dell PowerEdge Express Flash (PCIe SSD) backplane
•
2.5 inch x16 SAS/SATA backplane
•
2.5 inch x32 SAS/SATA backplane
Depending on the configuration, your system supports one of the following backplane combinations:
•
3.5 inch x8 SAS/SATA backplane and 2.5 inch x4 PCIe SSD backplane
•
2.5 inch x16 SAS/SATA backplane and 2.5 inch x4 PCIe SSD backplane
•
2.5 inch x16 SAS/SATA backplane for hard-drives in the hard drive bay and 2.5 inch x16 SAS/SATA
backplane for hard-drives in a flex bay.
Removing the hard drive backplane
Prerequisites
1.
Follow the safety guidelines listed in the safety instructions section.
2.
system battery slot
159
Advertisement
Table of Contents
Troubleshooting
