Idrac Settings Utility - Dell PowerEdge T630 Owner's Manual

Option Description
F1/F2 Prompt on Enables or disables the F1/F2 prompt on error. This option is set to Enabled by
Error default. The F1/F2 prompt also includes keyboard errors.
Load Legacy Enables you to determine whether the system BIOS loads the legacy video (INT
Video Option 10H) option ROM from the video controller. Selecting Enabled in the operating
ROM system does not support UEFI video output standards. This field is available only for
UEFI boot mode. You cannot set the option to Enabled if UEFI Secure Boot mode
is enabled.
In-System Enables or disables In-System Characterization. This option is set to Disabled by
Characterization default. The two other options are Enabled and Enabled - No Reboot.
When enabled, In-System Characterization (ISC) executes during POST upon
detecting relevant change(s) in system configuration to optimize system power and
performance. ISC takes about 20 seconds to execute, and system reset is needed
for ISC results to be applied. The Enabled - No Reboot option executes ISC and
continues without applying ISC results until the next time system reset occurs. The
Enabled option executes ISC and forces an immediate system reset so that ISC
results can be applied. It takes the system longer to be ready due to the forced
system reset. When disabled, ISC does not execute.
Related Links
Miscellaneous Settings
Viewing Miscellaneous Settings

iDRAC Settings utility

The iDRAC settings utility is an interface to set up and configure the iDRAC parameters by using UEFI. You
can enable or disable various iDRAC parameters by using the iDRAC settings utility.
NOTE: Accessing some of the features on the iDRAC settings utility needs the iDRAC Enterprise
License upgrade.
For more information about using iDRAC, see Dell Integrated Dell Remote Access Controller User's Guide
at Dell.com/idracmanuals.
Related Links
Device Settings
System BIOS
Entering the iDRAC Settings utility
Changing the thermal settings
Entering the iDRAC Settings utility
1. Turn on or restart the managed system.
2. Press F2 during Power-on Self-test (POST).
3. On the System Setup Main Menu page, click iDRAC Settings.
The iDRAC Settings screen is displayed.
Related Links
iDRAC Settings utility
70
NOTE: The default setting for In-System Characterization is subject to change
in future BIOS releases.