Enet Port Setup; Chapter 12 Enet Port Setup - ZyXEL Communications SAM1316-22 User Manual

C
H A P T E R
The ENET Port Setup screen allows you to configure settings for the Ethernet
ports.
To open this screen, click Basic Setting, ENET Port Setup.
Figure 42 ENET Port Setup
The following table describes the labels in this screen.
Table 17 ENET Port Setup
LABEL
Port
Active
Name
Speed Mode
Duplex
SAM1316-22 User's Guide

ENET Port Setup

DESCRIPTION
This is the port index number.
Select the check box to turn on the port. Clear it to disable the port.
Enter a descriptive name that identifies this port. You can use up to
31 ASCII characters; spaces are allowed.
Select the type of Ethernet connection for this port. When you don't
use auto-negotiation, you must make sure that the settings of the
peer Ethernet port are the same in order to connect.
Select Auto (auto-negotiation) to have the SAM1316-22
automatically determine the type of connection that the Ethernet port
has. When the peer Ethernet device has auto-negotiation turned on,
the SAM1316-22 negotiates with the peer to determine the
connection speed. If the peer Ethernet port does not have auto-
negotiation turned on, the SAM1316-22 determines the connection
speed by detecting the signal on the cable and using full duplex.
Select 10 Copper if the Ethernet port has a 10 MB electrical
connection.
Select 100 Copper if the Ethernet port has a 100 MB electrical
connection.
The SAM1316-22 uses full duplex Ethernet connections by default.
12
89