2684 Routed Gateway Screen - ZyXEL Communications SAM1316-22 User Manual

The following table describes the labels in this screen.
Table 66 RPVC ARP Proxy
LABEL
Routed Domain
Routed Gateway
Routed PVC
Aging Time
Apply Setting
Index
Gateway IP
VID
MAC
Flush

28.5 2684 Routed Gateway Screen

Use this screen to configure gateway settings.
SAM1316-22 User's Guide
DESCRIPTION
Click Routed Domain to open this screen where you can configure
domains for 2684 routed mode traffic (see
196).
Click Routed Gateway to go to the screen where you can configure
gateway settings (see Section 28.5 on page
Click Routed PVC to go to the screen where you can configure routed
PVC settings (see Section 28.2 on page
Enter a number of seconds (10~10000) to set how long the device
keeps the Address Resolution Protocol table's entries of IP addresses
of CPE devices using 2684 routed mode. Enter 0 to disable the aging
time.
Click Apply Setting to save your changes to the SAM1316-22's
volatile memory.
The SAM1316-22 loses these changes if it is turned off or loses power,
so use the Config Save link on the navigation panel to save your
changes to the non-volatile memory when you are done configuring.
This field displays the number of the IP address entry.
This field displays the IP address of the gateway to which the device
sends the traffic that it receives from this entry's IP address.
This field displays the VLAN Identifier that the device adds to Ethernet
frames that it sends to this gateway.
This field displays the subscriber's MAC (Media Access Control)
address.
Click Flush to remove all of the entries from the ARP table.
Chapter 28 2684 Routed Mode
Section 28.3 on page
199).
195).
199