Dhcp Snoop Pool Delete Command; Dhcp Snoop Lan To Lan Show Command; Dhcp Snoop Lan To Lan Disable Command - ZyXEL Communications SAM1316-22 User Manual

This command adds a static IP address to the DHCP snooping table on a port.
The following example adds two static IP addresses (192.168.1.10 and
192.168.1.11) to the DHCP snooping table on port 10 of the line card in slot 2.
ras> acl dhcpsnoop pool set 2-10 192.168.1.10
ras> acl dhcpsnoop pool set 2-10 192.168.1.11
ras> acl dhcpsnoop show 2-10
port enable static ip pool
----- ------ -----------------------------------------------
2-10 -
ras>

49.4.8 DHCP Snoop Pool Delete Command

Syntax:
ras> switch dhcpsnoop pool delete <slot-port> <ip-address>
This command removes a static IP address from the DHCP snooping table of a port
on the specified line card. The following example removes the static IP address of
192.168.1.11 from the port 10 on the line card in slot 2.
ras> acl dhcpsnoop pool delete 2-10 192.168.1.11
ras> acl dhcpsnoop show 2-10
port enable static ip pool
----- ------ -----------------------------------------------
2-10 -
ras>

49.4.9 DHCP Snoop LAN to LAN Show Command

Syntax:
ras> switch dhcpsnoop lan2lan show
This command displays whether LAN to LAN DHCP services are enabled or
disabled.

49.4.10 DHCP Snoop LAN to LAN Disable Command

Syntax:
ras> switch dhcpsnoop lan2lan disable
This command disables LAN to LAN DHCP services. By default, the LAN to LAN
DHCP service should be disabled except if you have the DHCP server connected to
one of the DSL ports.
SAM1316-22 User's Guide
192.168.1.10 192.168.1.11
192.168.1.10
Chapter 49 DHCP Commands
321