Reboot System; Command Line Ftp - ZyXEL Communications SAM1316-22 User Manual

Chapter 42 Maintenance
Click OK to begin resetting all device configurations to the factory defaults and
then wait for the device to restart. This takes up to two minutes. If you want to
access the web configurator again, you may need to change the IP address of your
computer to be in the same subnet as that of the default device IP address
(192.168.1.1).
Figure 129 Restore Factory Default Settings, Reboot

42.6 Reboot System

Use this function to restart the device without physically turning the power off.
To open this screen, click Management, Maintenance, Click here (Reboot
System).
Figure 130 Reboot System
Click OK. You then see the screen as shown in
again and wait for the device to restart. This takes up to two minutes. This does
not affect the device's configuration.

42.7 Command Line FTP

See Chapter 57 on page 375
device using FTP commands.
264
Figure 129 on page
for how to upload or download files to or from the
264. Click OK
SAM1316-22 User's Guide