Bandwidth Port Setup Screen - ZyXEL Communications SAM1316-22 User Manual

Chapter 18 IGMP
Table 37 IGMP Bandwidth (continued)
LABEL
Apply
Cancel
Index
Start Multicast IP
End Multicast IP
Bandwidth
Select
Delete
Select All
Select None

18.4.1 Bandwidth Port Setup Screen

Use this screen to set up multicast bandwidth requirements for specific ports. To
open this screen, click Advanced Application, IGMP, Bandwidth Setup, Port
Setup.
Figure 70 Bandwidth Port Setup
146
DESCRIPTION
Click Apply to save the filter settings. The settings then display in the
summary table at the bottom of the screen.
Clicking Apply saves your changes to the SAM1316-22's volatile
memory. The SAM1316-22 loses these changes if it is turned off or
loses power, so use the Config Save link on the navigation panel to
save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to begin configuring the fields afresh.
This table shows the multicast range settings.
This field displays the number that identifies this setting.
This field displays the beginning of the multicast range.
This field displays the end of the multicast range.
This field displays the allowed bandwidth for the specified multicast
range.
Select this, and click Delete to remove the setting.
Click this to remove the selected settings.
Click this to select all entries in the table.
Click this to un-select all entries in the table.
SAM1316-22 User's Guide