Body Solid SMR1000 Owner's Manual page 12

S T E P
2
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step.
NOTE
: Support Plates may have additional holes which do not affect operation.
A. Connect Rear Upright Frame (Q) to Right Base Frame (A) using:
Two 1 (M12x100 hex head bolt)
Four 8 (M12 washer)
Two 7 (M12 nylon lock nut)
B. Connect Rear Upright Frame (Q) to Left Base Frame (L) using:
Two 1 (M12x100 hex head bolt)
Four 8 (M12 washer)
Two 7 (M12 nylon lock nut)
C. Connect Cross Support (P) to both Rear Upright Frames (Q) with 50x215mm Support
Plates (R) as shown using:
Four 1 (M12x100 hex head bolt)
Eight 8 (M12 washer)
Four 7 (M12 nylon lock nut)
Do not wrench tighten until end of Step 3.
12