ACL application failure without an error message
Symptom
The system applies a packet filter or an ACL-based QoS policy to the hardware. However, the ACL does
not take effect.
Troubleshooting flowchart
Figure 6 Troubleshooting an ACL application failure
Solution
Choose a solution depending on the module that uses the ACL.
ACL used in a QoS policy
To resolve the problem when the ACL is used in a QoS policy:
1.
Verify that the QoS policy is configured correctly:
a.
Use one of the following commands to check the QoS policy for configuration errors,
depending on the policy application destination:
Destination
Interface
VLAN
Global
Command
display qos policy interface
display qos vlan-policy
display qos policy global
12