Replacing The Right Side Access - HP blackbird 002 Service Manual

18
Upgrading and Servicing Guide
c If necessary, lift the panel off the hinges.

Replacing the right side access

Complete the following steps to replace the panel and the inlay on the right side of the
chassis. If you remove the inlay only, skip to step 4.
1 To place the panel on its hinges:
CAUTION: To avoid damage, do not open the access panel more than
85 degrees.
a Position the panel at 85 degrees to the chassis.
b Insert the back edge of the panel into the chassis with the hinges over the
hinge pins.
c Lower the panel onto the hinges.
CAUTION: To avoid damaging the panel, check that both of the panel hinges
are properly seated onto the hinge pins before closing the panel.
2 Close the panel.