HP blackbird 002 Service Manual page 47

5 From the outside of the chassis, press the slot latch (E) to lock the card in place. (See
the Warning that follows.) The following figure shows a locked slot latch at (F).
WARNING: Do not force the slot latch to close. Check inside the chassis that the
card (G) fits against and around the alignment pin (H). Do not close the latch
unless the card is properly seated.
6 Connect cables to the card as needed.
IMPORTANT: Some graphics cards require two power cable plugs. These two
power cables must connect to power supply connectors that are in the same row of the
power supply. Do NOT connect the two power cables from one graphics card to
connectors on different rows of the power supply.
E
F
G
H
Upgrading and Servicing Guide
43