HP blackbird 002 Service Manual page 13

c
2 To install an inlay:
a
b
c
F
D
Lower the door onto the hinges.
CAUTION: To avoid damaging the door, check that both of the door hinges are
properly seated onto the hinge pins.
If necessary, place the door on its hinges as described in step 1.
Close the door.
On the outside of the door:
CAUTION: To avoid damaging the inlay, do not hold or pull out the inlay more
than 2.54 cm (1 inch) away from the door.
a To vertically position the inlay with the door, align the top row of snap
studs (F) on the inlay with the top row of holes (G) in the door.
b Lower the inlay onto the door just to the left of the slots (E), while maintaining
the vertical alignment.
c Slide the inlay toward the front of the chassis, inserting the three tabs (D) on
the inlay into the slots (E) in the door.
F
F
G
G G
Upgrading and Servicing Guide
E
9